Water Chiller
Process water cooling from +5 °C to +15 °C for production machinery, moulds, and plant utilities — from 10 HP.
A water chiller cools water that is then circulated to production machinery. On injection moulding, extrusion, or printing lines, stable water temperature governs cycle time and output quality. Water that runs too warm slows product cooling; water that runs too cold causes condensation on the moulds.
We size the unit from the heat load your machinery actually rejects, not from the horsepower ratings that happen to be on the market. The calculation covers required flow rate, inlet-to-outlet temperature difference, pipe length and diameter, and the conditions of the space where the unit will sit.
What we deliver
- Heat load calculation for the machinery and process to be cooled.
- Capacity and condenser type selection matched to the space and water availability.
- Unit, tank, and pump installation with chilled water pipework.
- Electrical and temperature control work including flow and pressure protection.
- Commissioning with water temperature measured under live production conditions.
General specifications
| Outlet water temperature | +5 °C to +15 °C |
|---|---|
| Minimum capacity | 10 HP |
| Condenser type | Air cooled or water cooled |
| Included | Water tank, circulation pump, control panel, flow protection |
| Installation | Indoor or outdoor depending on available space |
| Scope of work | Survey, design, installation, pipework, commissioning |
Typical applications
- Injection and blow moulding
- Extrusion and printing machinery
- Process cooling in chemical and food industries
- Plant utilities and equipment cooling
Other services you may need
Tell us what you need
For cooling work, send the room dimensions, the commodity, and your target temperature. For IT work, how many users, how many sites, and what holds work up most. We calculate what is needed and send a quotation with the reasoning behind it — at no cost.